The feed opening needs to be accurate when the feeder is added and slanting

　　The feed opening needs to be accurately positioned when the feeder of the ball mill is applied, and the medium-oriented mill is generally achieved by the electric motor. The medium and bulging of the mulch mill generally uses the motion of the motor, and the large ball mill uses auxiliary transmission, the auxiliary motor drives the auxiliary speed reducer, and then slowly rotates slowly through the main decelerator, the ball mill and the speed of rotation can be required to take the ball grinder. position. The ball mill speed is directly determined by the motion state of the mollow medium and the effect of the milling operation. When the speed is low, the ball in the ball mill is less than the height, and the gravity of the ball is slid down from the top of the ball, and the state is sized. At this time, the impact of the ball is very small, but the grinding is very strong. However, the ore is mainly ground and pulverized, and the mill is not high.

　　There are several aspects of the ball mill swelling belly, there are several ways to pay attention, one is to watch whether the ball mill is spitting, and the second is the sound of the ball, if the ball mill is swollen, the sound is small, The third is to watch the ball mill current control cabinet, especially to emphasize, if the ball mill is swollen, its current value is small, and many operators and engineers think it is just the opposite, they believe that the ball mill is blocked because the mine in the ball mill is large. Its current value is getting bigger, this is a wrong point of view. The ball mill belongs to the heavy-duty machine, the starter torque is large, in order to activate the motor to start under no-load, reduce the start current, usually equipped with a friction clutch or hydraulic coupler between the motor and the reducer, so that the motor is separated from the reducer Start under conditions, realize the no-load start of the motor.