Frequency conversion Ball Crusher

General introduction to Frequency conversion Ball Crusher

　　Frequency conversion ball mill is a necessary device for mixing, fine grinding, sample preparation, nano material dispersion, new product development and small batch production of high-tech materials. Frequency conversion ball mill adopts cog-type belt powertrain technology, which not only maintains the stability of gear transmission, but also overcomes the shortcomings of the original belt transmission which is easy to slip and the speed is unstable.

Advantages of Frequency conversion Ball Crusher

　　Frequency conversion Ball Crusher should be installed on solid concrete foundation. For the basic design and construction of ball mill, please refer to the General Assembly drawing and basic drawing of ball mill. In order to ensure that the position accuracy of each part of the ball mill does not change greatly during use, the foundation of the ball mill should adopt a monolithic structure.

　　After the compressive strength of concrete foundation reaches more than 75%, ball mill can be installed on it. Before installation, the quality of the foundation shall be inspected, and the concrete shall have no defects affecting the strength, the quantity and position of prepared hole shall meet the requirements, and there shall be no sundries, water accumulation and oil pollution within prepared hole. When the "ground method" is used for installation, the "central marking board" shall be embedded on the surface of the Foundation ". Draw all center lines on the basis before installation and make eye-catching punch marks on the "center marking board" as the center line reference during installation. Before hoisting, the parts of ball mill should be fully checked and accepted, and problems found should be dealt with in a timely manner.

Working principle of Frequency conversion Ball Crusher

　　Frequency conversion Ball Crusher is equipped with four ball grinding tanks on the same turntable. When the turntable rotates, the ball grinding tank rotates around the turntable axis while rotating around its own axis, making planetary motion. The grinding balls in the tank collide with each other in high-speed movement, grinding and mixing samples. This product can be used to grind and mix products with different particle sizes and materials by dry and wet methods, and the small particle size of the grinding product can reach 0.1 micron (I .e. 1.0 × 10mm -4).

Technical Data of Frequency conversion Ball Crusher

　　Frequency conversion ball mill is small in size, full in function, high in efficiency and low in noise. It is an ideal equipment for scientific research units, institutions of higher learning and enterprise laboratories to obtain micro-particle research samples (four samples can be obtained at the same time in each experiment), equipped with vacuum ball grinding tank, the sample can be ground in vacuum state. Widely used in geology, mineral, metallurgy, electronics, building materials, ceramics, chemical industry, light industry, medicine, beauty, environmental protection and other departments.