The ball mill is a key device for fine grinding material after crushing.

　　The ball mill is a key device for fine grinding material after crushing. It is widely used in many industries. When the user usually purchases the equipment in a conventional ball mill manufacturer, the manufacturer usually tells the user theory actual power. Why did you say that? This is because the ball mills are affected by various factors in actual operation, resulting in an increase in actual power, which factors will cause an increase in actual power? 1 The main purpose of increasing the power consumption of the abrasive body is related to the velocity of the grinding body and the ball mill. The power consumption of overcoming the friction is a combination of frictional power consumption of each component. In general, this part usually accounts for a small proportion. 2. The cause of ball mill transmission is exposed to the ball mill transmission, and the spherical mill is lowered, but the actual power is increased. After analysis, the power of the known lift is reduced, and the increased power consumption of the portion is obtained from the increase in frictional power consumption. This increase is due to the increase in friction between hollow shaft and spherical tile. When the power supply voltage is lowered, the dynamic lubrication conditions between the hollow shaft and spherical wattage are destroyed due to the low speed of the motor output shaft. Therefore, the lubrication between the hollow shaft and spherical watting is converted into boundary film lubrication through dynamic pressure lubrication. The friction coefficient will greatly increase. This results in a sharp increase in power, exceeding the safety factor of the entire transmission system. As a result, the elastic rubber block connection block is destroyed. Therefore, the main reason for the breakage of rubber block is due to the increase in power, and the main reason for the increase in power is due to the decrease in the supply voltage. The above is the main reason for the actual increase in the ball mill. When the equipment is running normally, normal power consumption is inevitable. When the power consumption caused by the transmission failure, it can be saved immediately by immediate maintenance measures.