The ball mill has a very wide application in the powder system.

　　The ball mill has a very broad application ball mill in the powder system in the powder system, and the ball mill motor is large. It is a large energy consumption device, so it is very important for energy efficiency and energy consumption for energy. . From the operational characteristics, the positions in the ball mill directly affect its production efficiency and energy consumption. When the amount of the ball in the ball mill is increasing, the power of the ball mill is increasing, but the powder efficiency will fall. The energy saving of the ball mill is currently only considered to be considered. Removing the liquid power coupling uses the power saving ratio of the inverter to 8 energy saving of the frequency converter, the energy saving of the energy-saving mode, and the two adds a total of 11 energy saving, which is visible, Variable conversion modifications for ball mills can also achieve energy saving. Increase filling rate, increase steel balls and speeding speed, can increase processing and reduce energy consumption. Reduce the rolling or high static pressure oil film main bearing of the self-weight and the crystal coefficient of friction, the load is reduced, and the energy utilization can be improved. To increase the production of mill production, the water spray in the grinding cannot be ignored. The grinding inner grinding can effectively take away the heat in the grinding, and achieve grinding inner cooling to prevent the abrasive. The inner water spray is determined according to the temperature of the grinding, generally not sprayed below. Further, the amount of water is fixed according to the incubation temperature, accounting for 1-2 of the cement amount, and the moisture of the injection in the inner water is completely evaporated, and the moisture is not residue. Solid from the grinding head can be sprayed. When the temperature of the grinding material is high, it is advantageous from the grinding head water, and in general, water is sprayed from the grinding. Grinding water water can increase production capacity by 5-10. At present, the main method of ball mill is detected: the weight of the ball mill is mounted on the ball mill, or the home improvement metering equipment between the raw material bucket and the feeder. This type of method has high investment, the amount of modified work is large, and the maintenance amount of the measuring device is also quite large; the application of the ball mill is differential pressure to determine the stock of the ball mill, but the water content of the material, the type of material or steel ball is different. It will have an effect on differential pressure; the amount of ball mill is measured by vibration amount. Due to changes in the type of material, moisture or steel ball in the ball mill, the vibration current corresponding to the same stock is different, and the measurement means will have an error, and the mass measurement of the ball mill is difficult.