The ball mill is detailed and busy repairing the damaged location.

　　When most operators are subject to doubts about the ball mill, they will usually correct the damaged parts first, assist the ball mills to rehabilitate normal operation; in fact, this practice is considered, in the premise of finding the woeing edge, Even if it can help restore the ball mill is operating normally, it is also possible to re-exhibit similar wear conditions again, which will only share the maintenance time of the equipment and the revision of this money. Therefore, we must completely solve the ball mill wear, we should first understand the grinding of grinding. Let's take a look at us on the part of the ball mill easy to wear.

　　Normally, the ball mill is easy to show the wear, which is a rolling bearing. Due to the long-term operation, the rolling bearing and the drive gear will present a meshing error, which may cause the rolling bearing to scroll the finely derailled appearance, which is caused by the rolling bearing The main reason. In addition, the general raw material liner also causes dramatic wear. Since the outer surface of the raw material is relatively rough, the hardness is very weak, and the slight operation will be worn, which will be worn for a long time. In this regard, the tensile mill should be supported. Dedicated rubber lining, the anti-fatigue wear of progressive equipment, extends the service life of the lining parts.

　　The new processes, new materials, and speed development of the mechanical industry have largely promoted the technical advancement of the mining. For these years, the ball mill has been widely used in more than ten mining companies, and the ball mill technology overcomes questions that the traditional cone ball mills and severe pollution are severe.

　　The grinding power of the ball mill has significant progress relative to the conventional crushing and ball milling techniques, and the wear is also significantly reduced. The replacement ball mill is pre-powder, which greatly progresss the hydraulic power, which is higher than the traditional ball mill. 50 ~ 100, low battery energy consumption of more than 30, low noise, small pollution, adjustable material fineness, high yield, etc., make the company's economic benefits have improved.