Six benefits of empty trial operation of the ball mill

　　Normal production, is the purpose of each machine industry, the use of ball mill machinery is no exception, then what should I do to improve the freight rate? The empty trial operation is a good measures, the specific process: the ball mill installation is completed, passed inspection qualified In order to perform empty trial operation, the ball mill test should be performed by the skilled ball mill operators, and strictly abide by the ball mill operation procedure.

　　(1) The continuous operation of the air operation is not less than 12-24 hours, and the problem should be solved in time.

　　(2) The air transition test machine can be used to carry out load trial operation, and the load trial operation should be carried out, and the load operation should be used to feed the discharge, avoiding the steel ball and the cylindrical liner. The necessary grinding and damage.

　　1, add appropriate materials and 1/3 of the number of steel balls (ball mass reference ball mill total map) test running 12-24 hours.

　　2, add to 2/3 of the number of steel balls to run 24-48 hours.

　　3. According to the ball mill, the production of qualified products, refer to the actual ball mill of the same type of mineral ball mill, determine the reasonable ball of this table, and perform a test run for no less than 72 hours.

　　(3) The increase in the amount of load and the length of the trial transport time are determined based on the running of the size gear and the gear gear (temperature rise, noise, tooth surface contact, etc.). Do not fully load before the contact accuracy of the tooth surface is not achieved.

　　(4) The test operation should work normally, the main bearing, transmission bearing, and reducer temperature should be normal.

　　(5) After loading 2/3 of the number of steel ball trial transportation 24-48 hours, check and tighten all bolts again.

　　(6) Trial operation should be carefully doing a good job. The ball mill is mainly used in the mixing, grinding of ceramic raw materials. It is the main equipment for producing all kinds of ceramic products.

　　The machine uses autographs and decompression, reducing start current, and its structure is divided into integral and individual types. Using triangular belt drive, single-stage or double-level deceleration, equipped with loading and unloading power motor.