Ball mill occurs in work in work

　　Ball mill steel ball is an important basic component of a ball mill. The ball mill steel ball is a ball mill. The material medium is grinding between the steel ball and the material between the steel ball. The ball mill steel ball is interpreted in the mineral industry. The role, no ball mill steel ball, there is no ball mill, two interdependeses, unacceptable as a whole, the spherical mill can work well, mainly due to the steel ball inside the ball mill can operate well. The ball mill occurs when the ball mill is working, and if the energy-saving ball mill is sticky in the work, we don't want to analyze the changes in the nature of the ore, give the mining, water supply, return volume, overflow Whether the flow rate is normal, after finding the reason, we have to treat the symptoms to find the correct treatment. (1) First we have to adjust the amount of water. The concentration of the mill used must strictly control, excessively or too small. When the concentration is too high, the speed of the slurry activity is slow, and the molar dielectric impact is weakened, and the overflow ball mill is thick, and the granular particle size is thick, while the grid ball mill may flourish. (2) When there is a sticky grind, another measure to take is to reduce the energy-saving ball mill to the mine or short time. This reduces the working load of the ball mill to reduce the passing mine.

　　(3) Reasonable addition of milling media. If the amount of the medium in the energy-saving ball mill is insufficient, it should be appropriately added to the appropriate size of the mill. At the same time, it is also possible to strengthen the dust-free air pressure, plus the mortar agent, and other parameters such as the slurry, viscosity, residue, etc. you get, if the specific gravity is high, will definitely have sticky, this can be appropriate The condenser and ratio increase the efficiency of the energy-saving ball mill. If the requirements for the viscosity of the slurry is not high, it can increase the ratio, but it is not too possible at all, and it is necessary to see your requirements for the proportion of the amount of water.

　　When the ball mill is used, there is often a phenomenon that is not started. Once the phenomenon that the ball mill is started, it has seriously affected the production progress of the cement plant and the distribution plant, which generally has three more common. First, the grinding body of the ball mill is too much steel ball or steel segment, and the start will become difficult. Therefore, when using a ball mill, it should be strictly followed according to the instruction manual, and the steel ball load must not be exceeded. Second, when the motor power is less than the rated power, it may be difficult to start. Three is the ball millInsufficient loading, there is also a case where it is difficult to start. According to the traditional design calculation method consumed by the ball mill power meter, if the loading is insufficient, it means that the amount of material to be worn by the material, the grinding body, the water and the carrier, and thus the grinding of the abrasive body is hit the material and the abrasive body. The mechanical collision is also reduced accordingly, and the power consumption will be reduced. However, this is not the case. In fact, if the loading is insufficient, the power consumption is larger than normal loading, which will cause the ball mill to start difficult.