There are many kinds of ball mills that are often used frequently.

　　There are many types of ball mills, but the ball mills used in different industries are not the same below to say that those who are commonly used. We have to know about the axis of the ball mill, measure, measure, height at the top of the hollow shaft on both ends Consistency, when there is an error, the feed end is allowed to be higher than the discharge end of the discharge end. At the bearing seat cover of the hollow shaft at both ends, the slits around the hollow shaft and the bearing pressure should be substantially consistent, and the inside and external compression should be The gap is basically consistent. If the contact marks are biased toward the end of the width of the tooth surface, that is, the tooth surface is not parallel. If the transmission large gear has a case where there is a case, it means that the gear gap is too small, and the pinion should be left out of the large gear. The transmission portion should be installed and adjusted according to the host gear in the ball mill transmission portion. Make the pinion width of the pinion evenly even uniformly in both sides of the tooth surface of the large gear. The tooth surface of the pinion is parallel to the tooth surface of the large gear, and the tooth side clearance remains 0.25 mm (approximately hard box cigarette packaging paper). From the contact marks of the size gear, the contact marks should account for more than 60% of the full length, and the height of the contact marks accounts for about 40%. The above is the rough introduction of the ball mill hopes to help everyone.