Wet ball milling requirements for cylindrical water in milling

　　Wet ball mills are high in wet milling production, the amount of water in the injector is high, which can not only ensure the normal operation of the wet ball mill, which can improve the production quality of the wet ball mill. The same is true in the gravel production line, because when the energy-saving wet ball mill works, the cylinder is an important part of the wet ball mill. It must have sufficient stiffness and hardness to make it better to produce an arm, but flow through the energy-saving wet ball mill.

　　The amount of water is an important parameter in operation, and the water volume also reacted the carrying capacity of solid particles in the wet ball milling, so that the moisture in the cylinder will affect normal production. The energy-saving wet ball mill is high, high water flow rate, has more solid particles carrying a damp ball mill, resulting in increased system cycle magnification; the water consumption of wet ball mill is low, the water flow rate is low, and the solid particles carrying a damp ball mill Less, fine, such a qualified particles still remain in the cylinder, which is unwind to finer granules, resulting in a decrease in cement energy-saving wet ball mill, and the unit power consumption is increased.

　　Therefore, the flow of wet ball mills should be corresponding to the wet ball mill, and to be controlled within a suitable range. Water flowing through the wet ball mill body consists of the bottom of the water and one, the secondary cyclone, one, the bottom flow of the secondary cyclone is generally unchanged in the shipping `line, so adjusting the amount of water to adjust the flow The water of the humid ball mill is passed. The operation of carrying water in operation is a certain proportion of energy-saving wet ball mill, and this ratio should be cautious.