Technical transformation, the ball mill has added a new purpose.

　　With the rapid development of the economy, the ball mill has also continuously develops reform to meet the needs of the market and users. After the ball mill has added some new purposes, let's take a look at it. Industry is not much attention to the power consumption of ball mills, and individual manufacturers have not counted individual statistics for power consumption. Today, in the pursuit of fine management, it is necessary to perform power statistics for single equipment, analyze energy consumption, and reduce energy consumption.

　　The core of this transformation is to reduce the load and ventilation resistance of the efficiency, increasing the cyclic load and increase the separation efficiency of the powder powder to restrain the system to a more efficient state. The impact of ball mill moisture on the kiln system has different understandings, the most intuitive belly is not smooth, and others are not obvious in production practice.

　　As for the water gas reaction in the high temperature of the kiln, only the water evaporation of the moils at the kiln pulverized coal temperature and the heat dissipation of the steam when the steam is heated to one level exit, avoiding the moisture of 1% -2% More investment or brings safety hazards. Reconstruction should be based on the actual situation such as coal, stroke, and support it with data. Through the urgent stopper, the water division curve is known that the coal surface moisture has been basically dried after entering the drying bin 2M.

　　If you want to further reduce the moisture, you need to enter the powder grinding of the grinding. The plan for the dry position, if necessary, can shorten the space for the powder grinding. The ball mill is retrofitted before the system considers the problem. Due to the mutual influence of the ball mass, the power of the selection machine, the control, the system ventilation, etc., so the preliminary program seminar should be considering, avoiding the production of milling the powder after the mill is reduced, and the powder is transformed. The reamer is insufficient to become a bottleneck. Using friction, mill pressure difference, etc., automatically controls the feed, reducing human factors, so that the mill is always in the best state. Another mill replenishing the ball and uses a similar method to achieve fine control to ensure a good effect.