How does the high-thin ball mill end cap leakage how to choose a repair material?

　　The air shaft in the ball mill is both into the mine channel and the ball mill end cap. Since there is a gap between the hollow shaft and the feed cylinder, the slurry enters the cavity between the hollow shaft and the feed barrel. As the ball mill operates the rotation of the air shaft and the feed bar, the end cover slurry will appear. Ball mill end cap leakage repair selected KN17 polymer ceramic polymer wear resistant glue small particles wear-resistant protective gel.

　　Surface Treatment: First clean the wear part impurities, the corner grinding machine polls the treatment of metal substrates, cleaning the cleaning agent and drying dry, surface treatment is related to small particle wear-resistant protective agent and metal substrate bonding strength.

　　Figures a layer of release agent with the feed cartridge with the feed barrel to facilitate disassembly of the feed barrel.

　　Mixed uniform KN17 polymer ceramic polymer wear-resistant protective glue small particles wear protectant is applied to the hollow shaft and the feed barrel fit surface, which can be assembled. .

　　After assembly, it takes room temperature for 24 hours to complete the curing. When the winter temperature is less than 15 degrees, heating to 80 degrees for 2 hours to complete the curing

　　PrecautionsWhen the temperature is less than 15 degrees, the rubber layer is not complete, the strength is low, and the temperature is required to 60-80 degrees for 2 hours to complete the curing

　　When the winter temperature is less than 10 degrees, KN17 is high. Molecular ceramic polymer anti-wear corrosion resistance protective glue viscosity, heating to reduce the viscosity, and then mix well.