How to solve the material waste of the ball mill in production?

　　The ball mill is a very common mineral distribution equipment. It is an indispensable device in mining production, and the ball mill is a device for energy consumption and material waste in all equipment. Theball mill mainly grounds the material until the granularity of the qualified, but during the operation of the globular mill, due to various reasons, the phenomenon of excessive pulverization will cause the particle size, how to avoid this situation? How to avoid the excessive crushing of the global mill reduction in production? Let's do a specific introduction to us.

　　First, before the steel ball, the appropriate diameter steel ball is determined, and the steel ball ratio is made.Second, the granularity should be manipulated within the reasonable range of the ball mill equipment.

　　Third, the movement of the grinding medium should be mainly based on the state.

　　Four, timing view, determine whether it is necessary to increase the number of balls according to the material status after the grinding material. Five, while timely excluding the aboils, the new coarse material is completed in time, so that the accumulation of the coarse material remains at a higher level.

　　Over-crushing of the global ball mill will not only waste a lot of materials, but also have a large waste on human and production time, power consumption, etc., suggesting that the majority of users must master each time Details, avoid excessive pulverization, reduce resource waste.

　　After the above introduction, I believe that you will know how to avoid the waste of  ball mills to reduce the waste of production, expect to help you. After the above method, it can greatly reduce the waste of the drain ball mill in production.