What situation is stopped in a timely manner?

　　When operating the rod mill, as long as there is no fault, it is not necessary to stop. However, if the device has the following cases, no matter what reason, be sure to stop in time, and do a good job. Preventing the abnormal device:

　　1, such as the lubrication system, the power supply system fault, or the device itself fault, when these faults cannot be processed under operation When you need to stop repair. 2, the rod mill bearings, motor, and slow speed, the temperature is higher than 80 ° C;

　　3, the power supply system appliance is faulty without charging;

　　4, the rod mill and the like have a spark, smoke or abnormal sound, and last time;

　　5, the system is not normal, suddenly break the oil, but the bearing is not overheated; the oil volume is small Reason.

　　When the above case occurs, when the above cases are used, it must be stopped at this time, do not continue to run it. Be sure to repair it after stopping, in accordance with the correct method during the maintenance.