Teach you how to distinguish between the rod mill and the ball mill?

　　The rod mill is roughly the same, but there are three points of distinction between

　　1. Roll mills commonly used steel rods with a mortary medium in a diameter of 50-100 mm. And the ball mill is used as a grinding medium. The length of the steel rod is 25-50mm in the cylinder, which is often used with a carbon-containing 0.8% -1% high carbon steel; the amount of the rod is approximately the valid volume of the rod mill. 35% -45%, when observed with the naked eye, the horizontal surface of the rod is about 100-200 m below the centerline of the cylinder.2. The ratio of the length and diameter ratio of the rod mill body is generally 1.5-2.0, and the inner surface of the lining plate on the end cover should be a vertical plane. The purpose is to prevent and reduce the steel rod in the cylinder Generate confusion, bending, and breaking to ensure that the steel rods are regularly moved. The length of the ball mill is smaller and the ratio of the diameter is smaller, and the ratio in most cases is only slightly greater than 1.

　　3. The rod mill does not have a plaid mine, and an overflow type, open-shaped mine is used; the diameter of the hollow journal in the mineral end is generally larger than the same specification ball mill. The rod mill cylinder speed should be lower than the working speed of the same specification ball mill, so that the medium within the diarrhea is operated.