Is the dry ball mill and a wet ball mill?

　　The investment of wet ball mills is substantially the same as the ordinary grinding process. The dry ball mill has a flap system. The hollow shaft sealing device at both ends of the ball mill body is too tight, or the sealing body is in contact with the axis. Please handle the above questions based on the cause. Only the side gap of the bearing bushing is too small, or the bottom contact angle is too large. The grinding cylinder is equipped with a hydraulic jack, providing many auxiliary equipment for most users. Energy-saving high-precision grinding equipment, while the auxiliary equipment of the wet ball mill is simple, and the material conveying equipment is simple. The side gap of the energy-saving ball mill is too small, the clearance is too small, the bearing bushing and the shaft are too large, and the heat is not easy to distribute. Too little lubrication, too much contact point, and cannot form a uniform oil film on the bearing. Therefore, the investment is about 5% to 10% lower than the drying ball mill.

　　The wet ball mill itself requires higher power than the dry ball mill. It has been updated and improved on the basis of a common ball mill to increase the strength of the product, the outer gear, the sprocket or belt drive and the strength of the binocar spherical mill.

　　The material is smoothly implicated into the chamber of the ball mill through the hollow shaft of the feeder. Grinding is an important step in the production of aerated concrete production. The abrasive process consumes a lot of electricity. The ball mill is usually a large motor in the aerated concrete plant. equipment. This will cause the high-speed shaft pinion of the ball mill on one side to drive the sub-axis large gear, and the splitter pinion of the ball mill will drive the balance, including three different types of ball mill.

　　The rotation of the cylinder will result in centrifugal force, which will cause the ball mill to reach the height and then drop. The ball mill balancing wheel is rotated to drive the intermediate shaft on the other side. An important apparatus for preparing aerated concrete raw materials is a ball mill for grinding lime, gypsum, sand, slag and other materials. The material can only be thoroughly mixed after grinding to obtain the desired fineness, but the energy consumption of the dry ball mill is added to the energy consumption of the wet ball mill.