What are the form of lime ball milling?

　　The feed speed is one of the factors affecting the grinding efficiency of lime ball mill, and the feed speed is determined by the feeder of the ball mill. The ball mill feed device is a complete system for the ball mill feed, and what are the form of the lime ball milling?

　　1. Feeding of a spiral blade feed end.

　　The material is entered into the charge tube by the feed port, and the steel sheet is made, and the spiral leaf and the separator are inserted. The tubing screw is fixed to the end of the hollow axial diameter, and rotates one of them, hollow The shaft diameter has a sleeve, and the sleeve is welded in the sleeve. When the tube and the sleeve rotate with the grinder, the material in the tube is entered into the tube, and the separator is inserted under the push of the helix, and the separator is flowed into the sleeve, and the material in the sleeve is in the sleeve. It is pushed into the grinding body under the action of the spiral blade. Between the feeding son and the takeover, a felt seal is equipped to prevent leakage.2. Feed ends in the form of a frustoconical funnel.

　　The material is added to the cone ball mill, and the scholar is supported on the holder, and the material is inserted from the son into the conical funnel, and the funnel is embedded into the end of the journalin. The funnel has a large central angle to ensure that the feed funnel can move in the axis to the cylinder, and the steel ring is used to protect the grinding head from the grinding body. Wear. . The ribs enhance the effect of grinding head, and the bracket of the ring, the steel ring is coupled to the grinding head. In this configuration, the inclination angle is greater than the rest angle of the material when designing a frutted cone.

　　3. Take the feed end of the feed a spiral feed.

　　This feeding device is only used on some original vintage wet ball mills, and the new ball mill is no longer adopted. Its structural hollow axis is installed in a fixed sleeve, and the bolt is driven in the sleeve, and the material is pushed into the abrasive body by adding the sleeve by the feed opening.